Just under 15 minutes for a fill to exactly 4500 psi at the tank, compressor only got up to 133 degrees F, and my finger shows that auto purge is doing its job with the moisture evac.
im going to have to revisit the auto purge time frame set. I had it set for 15 minutes, and I may drop it to every 5 minutes instead, cause it seems all my top offs have been under 15 minutes and I don’t want moisture sitting in the compressor if I can help it. Might as well, since it has this auto purge feature.
Today, I also tried my 90 degree fittings I put together and connected it at the discharge block of the compressor, but it leaked, so off it went.
All in all a good day. My synrod is doing a 40 shot/42 lbs foot shot count, Hatsan Bully is at 76.10 lbs. foot for 20 optimum shots, and the PRod is plugging along at 17 lbs. foot of energy for two whole mags(16 shots).
On that 30 cal Bully I’m averaging close to 875 FPS. This Bully is a thumper for sure. I was originally going to hunt down a regulator for it, but why? 20 steady shots is good enough, lol!
I may even re visit that 40/40 tune for the Synrod. Before the compressor came along, I can see the value of having 40 optimum shots. But now since I have no worries on an air source, I think I’ll ramp it up for more power for at least 20 shots. Hmmmm...
Got everything documented in my 2019 PCP log book, and have piece of mind that all is good. This compressor is awesome for the price point.
Upvote 0