Hello, just recently I'm trying an idea to support Maverick shroud in it's own independent support, support not taking from the frame post but at the flat face of the side rails (yes they do have just support by paper thin hanging down, the reason I've put 4 screws). Is there a reason the barrel are not to be too rigid in their position? Haven't tried testing yet but is there such reason the manufacturer didn't make that way? I'm also planning the perforated disk O-ring seal type like the Brokock shroud system (yes the shroud should be screw cap type for that instead of this carbon fibre tube). And I didn't like the Huma barrel tensioner rail since it catches the barrel only at the sleeves (i.e 14mm) which means the shroud is still floating around the barrel sleeves
