I recently purchased a Readyair unit used. I have tanks from 3 different manufacturers all with quick disconnect foster fittings. It will only pump up one of them. With the other 2 the fill pressure builds up within less than a minute and the pump shuts off without putting any air in the tank. My Hill hand pump works without issue on all 3. The tanks were all around 1200 psi before I started and I had the fill pressure set to 2000psi. TC
Umarex Ready Air Issues
- Thread starter trkychsr
- Start date
I have a Ready air and I have to replace o rings etc after 20 hours operation. I bought it in March 2021 so I have not used up 20 hours yet. One time I did not snug up the whip to the compressor and it would not completely fill up one of my rifles.
Upvote 0
Does the compressor read the full 2k psi before shutting off? Sounds like a check valve issue...
Upvote 0
Have you tried contacting Umarex? I have heard of a few people having issues with their and Umarex customer service is amazing and I bet they could get you taken care of.
Upvote 0
I would suggest calling their tech support and you may get a quicker response. I deal with them a lot and that have great customer service but emails can take a while sometimes.
Upvote 0
Sounds like it is fully operating as it should. Maybe there is more pressure in the other two tanks than it seems.
Upvote 0
I called and left a message one day ago Umarex wanted a name, phone number the issue. my issue is the M1A1 jams when I insert a clip. I received the thing on 3-26-2020. I will let you know what happens.
Upvote 0
I am new to this forum so will see if is helpful to me. So far so good. A little about myself- I am not a big air gun person but I have used them all of my life for fun. From BBs to pellet guns and rifles. I am a cybersecurity person and have been on for a long time. I try to keep a low profile.
Upvote 0
The Readyair is crap. I got a grand total of 15 hours of use from it while rebuilding the piston THREE times…….. and I babied the thing.
Upvote 0
I sent an email about a couple of days after my phone message (phone messages are rarely answered, why, because they are not in writing e.g. no evidence). S about 2-3 days later I got a response. Clear and concise, a time frame and a note that if they have any questions they will contact me. So far so good. I am not going to post their email to me, I will wait until the outcome of my request is complete.
Upvote 0
Well I have not heard from UMAREX so time to take the M1A1 apart myself. So it was easy separating the upper and lower receiver. I even made a video about it less the 2 min long. AT least I can fix it myself. The M1A1 has a simple jamming problem way to much fun not to shoot it. I will see if I can post the vid below; maybe it will help someone in this group. I hope so. Anyway I hope this helps, I still love the UMAREX brand Legends BB guns they are all really fun to shoot.
Upvote 0
Find out who manufactured it. Tuxing, Yong Heng etc. Then obtain parts directly from them. Quicker and cheaper then going thru the third party branders.
Upvote 0
It is important to know the Chinese writen language is pictographic. Western is alphebetic. The Chinese tech support works best with pictures. It can get frustrating trying to explain with text. Also, mutual respect is of utmost importance in Chinese society. Insults and disrespect will create dead ends.
Upvote 0