My usually reliable Uragan 25 started leaking during the last fill, completely dumped.
Anyone have a solution or experience with this/
Thanks
Anyone have a solution or experience with this/
Thanks
Uragan Leaking thru fill port
- Thread starter Bravo1956
- Start date
I had the same issue with a Benjamin Akela leaking at the fill port. It was just a bad o-ring on the check valve piston. Replaced the o-ring and all is well. All I had to do was remove the foster fitting. The check valve slides into to back of the fitting. Not sure where your check valve would be with a probe-fill gun, but it'll have a check valve there somewhere.
Last edited:
Upvote 0
All good but dissembling the Uragan, makes me appreciate my FX airguns.
It is fragile and tricky. Next time it will take me 10 minutes instead of hours.
Anthony from Talon Tunes was answering my tech questions even on Sat and Sun!!!
I am surprised this is not more common given the design.
It is fragile and tricky. Next time it will take me 10 minutes instead of hours.
Anthony from Talon Tunes was answering my tech questions even on Sat and Sun!!!
I am surprised this is not more common given the design.
Upvote 0
Usually is a bit of something stuck in the check valve that can be cleaned up pretty easily,...You can try first to pack silicone grease in the foster connection and in the grove in the probe and blast it in there, somethimes thet works, if not just open up the fill unit and clean the check valve.
Last edited:
Upvote 0
Hey , I have the same issue with mine, mines only 5 months old, I was wondering did you do it yourself or did you have someone else do it. I got mine from Krale overseas so I doubt if I will get any help from distributors over here. Thanks, Richard.
Upvote 0
Thanks for the heads up. I contacted Krale but they havent got back to me yet. I took the side plate off,had one look at it and put it back on, your much braver than me.
Upvote 0