Airgun Technologies Vulcan 3 barrel

[carpmaster]

Hello everyone, I ask you a question, I tried to ask AGT, they answered, but not fully.
If I buy a Vulcan 3 today with 700mm barrel, say in .22 and .25 calibers, what barrel would be installed? I mean brand, twist rate, choked or not, rifling or polygonal...thanks for the answers

 

[RadarMan]

Hello Carpmaster (from Italy!), I Think the Vulcan barrels are as follows:

All of them at this point are CZ cold hammer forged. Only some of the very early Vulcan 3’s had a very hi grade of Russian barrel & (as I understand) one can Not identify them by any markings.

i have a V-3 / 700mm / .22 cal. and it does have Polygonal Rifling. The surface finish inside my barrel is just Beautiful, Uniform and Smooth. Zero tooling marks anywhere.

all OTHER Vulcan 3 Calibers , though, are Conventional / Traditional Rifling in CHF CZ barrels.

That is what I believe is correct for this rifle.

Stay well I’m that lovely area up against the Dolomites(?). I hope the Tourists are much fewer in number than the madness elsewhere. Steve

 

[Emu]

If you buy now a Vulcan 3 700 mm you will acquire one of the most accurate rifles at 300 yards in the market.

AMAZING !!!

 

[shaman]

CZ, 1:17.7 twist,w/o choke, standart rifling for .22 and .25
for .30 the twist rate is 1:15,7

 

[carpmaster]

This is the information I was given by AGT:
"All the barrels are without a choke.
All barrels, except one, are with conventional rifling.
A 700 mm long barrel in cal.5,5 mm (.22) is with polygonal rifling."
I have no idea about the manufacturer of the barrels and twist rate