Hi everyone, can you help me, I need to know the exact measurements of the screw in the photo. Thank you
Airgun Technologies Vulcan 3 magazine
- Thread starter carpmaster
- Start date
Morning! If you have a hardware store locally they should be able to help you figure out the measurement.
Upvote 0
I measured 2,41mm diameter which can only be 2,5mm nominal.
The TOTAL length of the bolt is 6,21mm and from my experience it's too short to begin with. Bolt length is generally measured by the thread so it must be taken into consideration here. These bolts are M2,5 x 5mm or M2,5 X 6mm.
Do yourself a favor and get longer ones as well. They cost something like 10c a piece and there should be space for it in the magazine. I would go for M2,5x8 because I'm with the o-ring mod. Just do not overtighten.
Good luck finding them
The TOTAL length of the bolt is 6,21mm and from my experience it's too short to begin with. Bolt length is generally measured by the thread so it must be taken into consideration here. These bolts are M2,5 x 5mm or M2,5 X 6mm.
Do yourself a favor and get longer ones as well. They cost something like 10c a piece and there should be space for it in the magazine. I would go for M2,5x8 because I'm with the o-ring mod. Just do not overtighten.
Good luck finding them
Upvote 0