I have tightened my safety slide several times but as I use it, it keeps loosening up. I tried some lock tight but it's still getting loose (maybe I didn't use enough?). Anyway, anyone else have this issue and how did you fix it?
Vulcan safety keeps getting loose
- Thread starter Daxx
- Start date
Your the 1st I seen with this issue, you let the lock tight cure over nite?, it's not something you just put on and use right away.
I'll look over mine and see why it get loose, I never use my safety, I de
cock if I can't shoot right away. Don't trust safety when I have 6 OZ 1st stage only setup.
I'll look over mine and see why it get loose, I never use my safety, I de
cock if I can't shoot right away. Don't trust safety when I have 6 OZ 1st stage only setup.
Upvote 0
It's just two screws. There are no washers or lock washers, so moving the safety eventually backs out the screws because you can't tighten them down, if you do the safety won't move.
Upvote 0
Maybe you can put a spacer between the screw head and the metal block so you can tighten it down good and still allows the safety slide to move. Like a cut down hollow metal tube that fits around the bolt's diameter tight.
Upvote 0
Hmmm... You got me thinking. Or maybe Teflon washers with metal washer on top and lock washer on top of that?
Upvote 0
I would remove that kind of safety completly. I guess it is enforced by the politics in some countries. The safety should always block the hammer, not the trigger.
Upvote 0