My dilemma. My son competes 10m 3p air rifle. His LG400 alutec has been inconsistent for some time now. Finally found a few good videos and found the recoil absorber is not following the action back forward after reloading. Supposed to return via magnet from what I could see, but unfortunately it is not. I can slide it forward via a tooth pick, but after cycling the action it does not return forward. Basically it is not functioning . Any advice would be great!!
Other Walther LG400 absorber not working properly?
- Thread starter Jaysbass
- Start date
I would reach out to Champions Choice in LaVergne, TN. They're an importer for Walther and may be able to help.
Upvote 0
Walther has provided me with good service. I had them help on a LG30 Dominator, but my LG400 has never missed a beat. Good luck.
waltherarms.com
Contact Us
Contact Us Connect with our team. 479-242-8500 EXT. 7 [email protected] Mon – Fri, 8am – 5pm NOTE: Use the Customer Support form for repair requests. Use the Optic Plate Request form to order your optic plate. For US Customers only, outside of the US please contact Walther Germany.
waltherarms.com Upvote 0
I resolved the problem, not exactly sure how but it's now working. The magnet was not catching the bolt when action was opening. Pulled the assembly out of the stock, then pulled the cap screw covering the absorber. I cleaned everything as good as I could and reassembles. Now it is working properly. Sounded much louder and is now consistent. Before shots were all over the place.
Upvote 0
Thanks for your post. I have an LG400 arriving tomorrow. I'm looking forward to a lot of ten meter holes being punched.
Upvote 0
Now I need to adjust the absorber travel. There is a small hex screw that adjusts how fast air escapes as the absorber travels rearward during a shot. Good video on YouTube. Enjoy your new hole puncher!!
Upvote 0