D
Deleted member 58109
Guest
i think i finally found a real good replacement o ring for that 2.84 x2.62 that drags on the valve rod.
after taking the gun apart and completely cleaning every bit of factory grease out of it.
i was inspecting the plenum tube i noticed that it didn't have the small white o ring like i see people replacing, it was black.
and dragged across the rod bogus.
then i thought of Polyether Urethane did some math and came up with these.
1/8 id x5/16 od x 3.32cs Duro 90.
long story short got some swapped it out best thing since sliced bread.
shot strings from sitting don't matter here is 2 shot strings from today after the gun sitting 24 hrs.
its tuned for 32g aea slugs rolled the wheel from 11 to 5 no other adjustments and shot jts 29,34g semi domes.
reg is set 128-130
after taking the gun apart and completely cleaning every bit of factory grease out of it.
i was inspecting the plenum tube i noticed that it didn't have the small white o ring like i see people replacing, it was black.
and dragged across the rod bogus.
then i thought of Polyether Urethane did some math and came up with these.
1/8 id x5/16 od x 3.32cs Duro 90.
long story short got some swapped it out best thing since sliced bread.
shot strings from sitting don't matter here is 2 shot strings from today after the gun sitting 24 hrs.
its tuned for 32g aea slugs rolled the wheel from 11 to 5 no other adjustments and shot jts 29,34g semi domes.
reg is set 128-130