Want to get a Falcon scope for FT but need a comma wheel? Here’s how.

[davecole]

I spoke with Jody over at https://dmpc3d.com/ about a comma for my Falcon scope. He currently only offers one for Hawke and UTG but was willing to make a prototype. 

Having nothing more to go on than a few photos and dimensions followed by a couple of phone conversations and emails he sent me this one along with a pointer. It’s super close to being a drop in/on comma. With a little tweaking here and there it will be THE scope wheel for Falcon scopes.

Ill be getting back with him with more feedback so you can save some serious money over the really fancy machined aluminum models currently out there.

Also, I picked up a single shot tray for my FX Wildcat which also provides a nice cheek weld for left-handed shooters.

www.smwengineering.co.uk

 

[kayaker]

Dave did you have to drill & thread it for the set screws ? Thanks for showing Darell

 

[davecole]

No sir. Jody drilled, tapped and installed the set screws prior to sending.

 

[kayaker]

Thankyou

 

[Josparky]

https://youtu.be/cnNubES4rdw

 

[Guest]

Yes, 3d printing is the way to make those. It is both inexpensive enough and accurate enough. This is a good application for 3d printing because the market does not produce the demand necessary to support the costs of injection molding. Now working on a design for some of my scopes.