N/A Weihrauch

[rapstarD]

Hi Everyone. I’m looking for what the best lubricant product is for my weihrauch hw springers is. I dont mean for the powerplant inside the rifle, but for the rotating pieces of metal with friction when I’m cocking and loading my break barrels. Ive tried a few searches and read the care portion of the manual but Im still not sure what the best is.

Thanks!

 

[markhooper]

Hi Everyone. I’m looking for what the best lubricant product is for my weihrauch hw springers is. I dont mean for the powerplant inside the rifle, but for the rotating pieces of metal with friction when I’m cocking and loading my break barrels. Ive tried a few searches and read the care portion of the manual but Im still not sure what the best is.

Thanks!

I don't know what is recommended for them but I still have a bottle from 25-35 years ago that I used for my Beman P1 and rws 34 and 48.. and it was good for the joint and finish on the metal and it was also good for the power plant.. I'll try to dig it out and see what it name is.. it's was special for spring break gun.. I think I got it from the same place I got the rws.. and I like it was good for all the metal parts and just used hoppy gun oil for stock polish and wiping down the outside when I was outside during the winter..
PM me if you want to.. because I will probably not be able to find this thread again and well I can look tonight or tomorrow and send you a picture of it..
had a straw for lubing the chamber too and it didn't make any dieseling.
Mark

 

[SpiralGroove]

ARH makes Clear Tar for rotating metal pieces. I use this on most external metal joints.

LARGE Clear Tar- Improved

Maccari Custom Airgun Shop. Airguns and related accessories. Springs,tune kits,gunstocks,Beeman, Rws, Webley and many others. Sales and service

www.airrifleheadquarters.com

 

[MEC17670]

On the washers inside the barrel yolk, I use a tiny be of moly.
Unless you want a "dieseling boost" do not put any lube in the chamber. It could cause detonation which can do serious damage.
For all the lub points, Ballistol will work fine.

 

[marflow 777]

i happen to use Ultimox 226 inside and out or it's other name krytox 205
you need very little and it is very expensive

 

[Mycapt65]

Moly paste on the the pivot parts and detent. It sticks well to the parts and provides long lasting protection. The only downside is you have to disassemble the rifle to properly remove the pivot bolt and shims. Refrain from using oil as it will wash out any grease in there and won't protect as well or as long as the grease it removed.

 

[Hateful McNasty]

I use copper loctite antiseize. .

 

[bustachip]

i happen to use Ultimox 226 inside and out or it's other name krytox 205
you need very little and it is very expensive

Same here, one lube for everything.

 

[Frank in Fairfield]

This is what I use:

 

[coastal drifter]

clp wprks pretty good