What did you order / receive airgun related today? Thread

Christmas, twice today. Headed down to my wood shop and this was at the door. More targets. Crow
IMG_1238.jpeg
 
Christmas, twice today. Headed down to my wood shop and this was at the door. More targets. CrowView attachment 544718
Those look like fun. For indoors I carved out a form in hard maple, acraglassed the inside as a mold, then made figures of duct seal. They would release well and shot them off the old outers 22RF bullet trap. Lots of indoor fun with the low powered guns. They were reuseable until they picked up too much dirt. Be Well Brothers, Bandito.
 
  • Like
Reactions: Rondo and crowski
From what I've been able to find, Fed Ex may have delivered the last one of these available today....AEA Standard Challenger 24" .35 caliber. I don't think AEA will be making any more in this caliber. Just finished mounting a Hawke Vantage 3x9x40 AO and am waiting on a mold and sizing dies. I'm sure this won't be my last mold I try for this one either!
IMG_6691.JPG
 
  • Like
Reactions: Bandito
Sleestak have you had those pouches long and would it be simple to attach a neck cord? I would like to carry it outside of clothing when hunting. Have I mentioned DEATH TO SQUIRRELS? Be Well Brothers, B.
I bought one years ago at the dollar store & just repurposed it recently as a pouch. It works perfectly. You can just unzip.it a bit and pinch it to open it up enough to orderly drop some pellets out.

It's easily solid enough that it'd be very simple to attach to a cord.

The shipping is more than the product, so.it pays to buy enough of them to make it worth while. & is not like they have an expiration date

100% would recommend
20250308_115215.jpg
 
Last edited:
  • Like
Reactions: Bandito
Received, a few days ago, 3 Reximex Silent Force moderators, unboxed and tested them on 3 different .22 and a .25 yesterday. All were more than backyard quiet. Only 1 inch diameter so no fat tube on the end of your gun. Best part, around $32 each shipped from www.sharg.pl (Poland). Best deal for a moderator.

20250308_033400.jpg

20250308_033432.jpg
 
  • Like
Reactions: JaceSpace1369
Received the Hatsan 130 QE 30 cal. Had a cheapie scope and cheap( ier ) rings, no arresting pin but holes in the top of the mount. The scope even tightened and cranked tight moved in four shots, a lot! I installed an arrester block with pin. But I don't think it will do the job. It of course diesels heavily with heavy smoke. I am going to need installation of a ring set with arrester pin. A heavy set. I think I have one in a scope mount drawer. I buy a couple of sets and when I use one it gets replaced. Most of the time I have whatever I need. My "brother" from another mother is going to be astonished. Those 44 gr pellets will be effective on varmints after his chickens with little noise. Am concerned about his ability to cock it after his stroke. Will see. A piece of tubing with a cutout for the front sight can add leverage to cock the gun. Being both a gas ram and new makes it interesting. I would go with PCP but he is always talking what if the electricity goes out ?¿ ? Be Well Brothers, Bandito.
Nice pic...thank you