WHICH RINGS ?!?

[Hapo]

...I found two sets of rings I liked @ the same price with the biggest difference I can see being one set is fabricated with 7075 and the other 6061...

https://www.amazon.com/gp/product/B07M7LDSG1/ref=ox_sc_act_title_2?smid=A1Y49AICJXP0NC&th=1

https://www.amazon.com/gp/product/B08BJD8HWL/ref=ox_sc_act_title_1?smid=A2UC2E5NACFGWB&psc=1



https://www.clintonaluminum.com/6061-vs-7075/

 

[Skip-in-WV]

I like the F X no-limit rings for maximum adjustment. I have 3 sets.

 

[davecole]

You will see zero difference in either grade aluminum as far as scope rings are concerned. That is, unless, you’re going to use them as jack stands.

 

[Glem.Chally]

You will see zero difference in either grade aluminum as far as scope rings are concerned. That is, unless, you’re going to use them as jack stands.

Heh.

 

[Odoyle]

Pretty dang expensive rings!

 

[d3vnull]

I can't find place of manufacturer on the Arken rings. The Vortex rings are USA made if that matters.

 

[DarkSights]

I would think that getting adjustable rings would be much more important than the material the rings are made from. The stresses seen in the scope rings seem pretty inconsequential - even in a springer..

 

[GeneT]

Take a look at the Monstrum 30mm mounts - mount + rings for ~$30 on Amazon. The only downside to the Monstrum mounts are that they use the little torx screws (same as the ring tops) to mount to your rail, rather than the usual crossbolts. 

GsT