Daystate Wolverine magazine removal

[PNEUMATIC]

Hi guys,
I just received my Wolverine and test shot it a few rounds. I was unable to remove the mag until it was completely empty. Is that by design, or should it remove at any time?
Thanks

 

[Ezana4CE]

I have no idea, but providing a little more info may prove helpful. What type of ammo are you shooting (brand, grain weight, caliber)? Maybe @Emu can help.

 

[elh0102]

Hi guys,
I just received my Wolverine and test shot it a few rounds. I was unable to remove the mag until it was completely empty. Is that by design, or should it remove at any time?
Thanks

It should remove at any time.

 

[PNEUMATIC]

It should remove at any time.

Thank you elh

 

[oledawg]

Yep you should be able to remove unless you have pushed the pellet a little ways out. There is nothing holding the mag in other than the magnets.

 

[elh0102]

I assume you have the new style mag. Since the pellets are not held in place by an external O ring, if the rifle is slanted slightly downward, and the mag is touched enough to slightly move the cylinder, the pellet is released, and will slide forward enough to jam the mag in place. IMO, the CARM mag is the best solution.

 

[Emu]

The pin could avoid the magazine to exit…., But irrespective of empty or not…..

Maybe a slug too slim that move inside the magazine……

If it does not jam with JSB pellets, then it is a slim slug causing the problem.