I got myself a 800fps air gun and a optic(Beeman 3-9X40).But no matter how much I try, the pellet wont hit the target.I tried to zero the scope but no matter how much I turn the dial on the bottom right (The dial which which is used to change the direction from left to right) the pellet wont hit the target.

I would alawys hit the pellet about 4 inches left from the target.,I tried turning the dial right(about 20-30 clicks,when 2 or 3 clicks didnot work) but still the pellet will the same spot,eventhough I turned the dial to the right.
Why wont the pellet hit to the target no matter how much I turn the dial to the right.The horizontal height is correct so I dont need to change the dial on the top of the scope.

Am I doing something wrong?

Are the carbon fiber barrel sleeves used in conjunction with the barrel housing or do they replace them?

Whats the best regulator pressure and the best power wheel for jsb 18 grains and javelin 21 grain slugs?

I’m looking to get a PCP for coyote hunting. What are my options for around $1000 or so. I already have a compressor and night vision scope. Preferably something not too heavy and not single shot.

valve replace for 0ne hr fireman tank
will the above regulator/valve fit this tank?
Hopefully the full picture of the valve will show
If not what which one will I need and
where to get it?
I am new to this air gun stuff and have
a lot to learn
thanks
I purchased this valve before getting the tank

Can someone tell me what I need to change the air tank on my Vulcan 3, I have a 580cc tank as original equipment and I want to change it for a 700cc one? alsafe

Hey guys I seen a nice gun on here that fits what I’m looking for. The seller is pcp airfunner and would like to get in contact with him. I’m new to the forum so if anybody knows him and can get him to send me a pm. I can also give my phone number to chat. Thanks so much

Hi,

Retired last year and finally got to repair my old Air wolf .177. It is an original. I had to put it in the closet for about 10+ years. it was fussy and consumed too much time.

So this is the first version with just the electronic trigger. Bought it used , and it is an extra FAC . Anyway , new battery , new seals
good cleaning and it works but has shot like garbage mostly. I bought a Huma reg and installed.

I Tried the huma at higher setting 140 bar , no resolution on the electronic settings, Just dialed it down to 110 , still the lowest setting is the best for accuracy. Any thing higher and the group open up. I plan on getting the 120-125 huma suggests.

Some problems with consistency, I shoot near 1 moa and then it opens opens up. It only shoots decent on the lowest electronic power setting.
I am thinking it is way over powered for accurate shooting, I am considering now replacing the main valve spring with something heavier if nothing else to give me resolution on the electronic power setting. Current one is about 13.3 in-lb, thinking of at least tripling it.

I did polish the barrel , it did help and tightened the groups. The barrel was loaded with lead dust and wax .

Even 10 + years ago , it never really shot all that well.

Just wondering if anyone else has made the journey here. advice appreciated.

I have a BSA Gold Star in 177 one mag. minty cond. Shoots great. But no listing in the Beeman blue book of airguns?what kinda vale is it worth?For some reason its not listed some of the other BSA's are? It caint be that rear? thanks Willy

I want to make a gauge pressure line for my wingman tank to check pressure before filling any Comments or suggestions for this?

Anyone own one of the replica air/handguns like Glock, Sig, Beretta, ETC? any suggestions for a decent quality model that shoots fairly well and accurate out to say 15 yards.

Does anyone have any suggestions for the Airacuda max shooting slugs for accuracy at 100yds? I'm just wanting to hunt small game out to 100yds and need advice on slug choices and settings. Any help would be greatly appreciated. TIA

I received my .25 RAW Hm1000x yesterday and I have a few questions.

I did a search, and it looks like there are a couple different answers but the 480cc carbon tank says it's good to 250bar but the manual says to only fill to 230bar. It's no big deal to only fill to 230 if that is what the specs call for, but I did see some people that said the reg and the tank can both handle 250bar without a problem.

I ordered a left-hand rifle because I will only be shooting benchrest and wanted the cocking lever on the left side. On the left hand rifles the fill port is actually on the left side of the rifle but I would rather have it on the right side. From the vids I have watched it looks like you can just remove the tank and flip the port and gauge around, so they are on the opposite sides, is that correct?

Last question is what moderator should I go with to quiet this rifle down some? Looking for the best bang for the buck.

Is anybody makeing more then a 10 round mag 22cal. for the Marauder?

Has any one shot full metal jacket .457 slugs throw their texens or 240 gr copper throw any of their big bores? I am just wonder if they shot better or produce any more fps and fpe?

Where is there a Diana Repair Facility.. in the USA for Diana 10 an Beeman 900

Anyone having a moderator clipping problem on Airacuda Max .30 ?

3 Dec 2023 UPDATE. I received another Max in 30 caliber from Pyramyd Air a few days ago. This replaced my previous three Max, one in each caliber that were clipping moderators due to a manufacturing defect in the air gun not the moderator. This defect has been extensively reported and commented on through most of the appropriate forms. So it's likely my new Max in 30 caliber was from a batch wherein the defect has been corrected. That means that I shot my Airacuda Max in 30 caliber with the Ronan 35 caliber moderator and it did not clip and it shot very accurately and substantially reduced the report.

I have an Aim Sports Alpha 6 4.5-27x50 SFP on my Fortitude .177 and nearly always have it at the max, 27x, zoom. Even as close as 10 yards.

I have an Athlon Argos Gen1 8-34x56 FFP on my Akela .177 and nearly always have it at the max, 34x, zoom. Even as close as 15 yards.

When lighting conditions and time allow, I always prefer to take my shots, even at very close range, at max zoom.

I am the oddball and I know it. However, I would like to hear from you folks.

What is available in FFP that has at least 30+ max zoom and 10 yards to infinity focus/parallax.

Yes, price IS an object, but if the glass is good, and it can hold zero, that is all I need. I use holdover and don't intend to click for range.

Price range is "cheap". (smile)

Under $500, preferably MUCH less than that.

Thanks!

All my best!

Kerry

Have any of you changed the caliber, liner or length of their fx dynamic Or panthera? If so how hard or how did you do it? Can’t find much online

Hay guys,the Notos,could a guy take off the connection were the stock meets the action?and adopt a wood stock to it to take off and on? Im just not a black gun or assault gun kind of guy.Maybe a little wood on the forearm? Thanks i dont have the rifle yet?just trying to cover my bases.

I'm pretty new to PCP rifles, but I've been lurking around forums for awhile reading. I have a Flashpup QE, but I'm looking for something a lot more capable (it's fine but feels like a starter rifle). The FX Impact and the platform in general looks extraordinarily appealing to me, but I don't understand it all yet and have a few questions on how to get started.

I have some interest in the flexible aspects of the M3 and the ability to change barrels, setups, etc. but I'm curious what some of the true "best practices" have yielded regarding this flexibility. I get the impression that while it's flexible, many still prefer to have multiple rifles instead of constantly changing setups. Is this a correct impression on what most of you do? Is it a big deal to swap back and forth between pellets and slugs of the same caliber on one rifle or does it get cumbersome? I've gathered it might not be worth swapping between calibers, but it's not as clear to me how feasible it is to often swap between pellets and slugs on the same gun on 1 caliber.

I'm asking because I have some interest in dabbling in slugs to explore shooting some longer ranges. It seems like it's definitely a capable slug gun, but I wouldn't expect to only want to shoot slugs.

What are your experiences on the FX M3 platform and the true practical side of its flexibility?

I have a dynamic .25cal 700mm and when I chamber the 1st shot the speed is low but the next shot speed is normal.
I suspect a leak somewhere in the chamber area but a soap test did not show any leaks.
Anyone else have this issue ?

I just received a tuning kit for a Mk. 1 BSA Supersport. The kit includes some "ultra grease" and "ultra lube". According to the instructions the grease is for the mainspring and lube for the piston. There's nothing mentioned about lubricating the piston seal. Does it not require any lubrication?
The kit also includes a washer labelled, "top hat front disc & spring guide disc (rear)". I assume this sits between the top hat and end of the piston?

I recently picked up a huben gk1 .25 and it is my first pcp airgun. In the manual it says to not let the pressure drop below 12mpa nor take it above 35mpa but is it okay to leave it pressurized anywhere between those 2 points if being stored for a couple weeks time? What...if any is the ideal storage pressure? Thanks for any insight you can provide.