DAR Dar Gen 3 reg

[Shaky2]

Hi everyone. I have a Dar Gen 3 that the regulator quit working. While trying to get Dynamic to message or call me back I contacted Huma Air and they asked me give them some dimensions of the old reg and they would see if they could make me one. Well they did and I got it today.

 

[Privateer]

Pictures and measurements Please?

 

[Shaky2]

Measurements of what?

 

[Privateer]

Just the diameters.
But it looks to me as if it will work in the Huma Reg tester!

 

[WorriedMan]

Shaky2,
Well done, I suspect this regulator will fit the Airacuda Max, as well. Both made in same factory and side by side similarities are uncanny. WM

 

[Shaky2]

Shaky2,
Well done, I suspect this regulator will fit the Airacuda Max, as well. Both made in same factory and side by side similarities are uncanny. WM

I'm sure it would.

 

[Shaky2]

Just the diameters.
But it looks to me as if it will work in the Huma Reg tester!

They made it off my measurements with a digital caliper. Outside diameter is 17.98mm

 

[Shaky2]

I installed the reg. After 41 shots I got 2 shots at 932fps, 5 at 939fps and 34 at 936. I'm very happy with that. It was wild chrony kept showing 936 again and again

 

[Shaky2]

Good news! Huma Air said they would probably make a batch of the regs in 2 or 3 weeks

 

[Shaky2]

UPDATE......Dynamic Air Rifles finally got back to me. After explaining my regulator quit working and couldn't get a reply from them and telling them that I had Huma Air make me one they sent me a complete regulator set ready to install including pressure gauge. They also sent a complete oring rebuild kit. I thought I would get a reg and nothing else but I was wrong. A little late but in the end they did take care of me. He said they made some changes and contacting them shouldn't be a problem anymore.