I just found one that has a couple of leads attached. I’ll just wire it to the 12v leads on the power supply because essentially the runtime of the power supply is the same as the run time for the pump plus a bit extra.
Upvote 0
GX-CS4 $529/$477 with discount code
- Thread starter BackStop
- Start date
I just found one that has a couple of leads attached. I’ll just wire it to the 12v leads on the power supply because essentially the runtime of the power supply is the same as the run time for the pump plus a bit extra.
I got this one https://www.amazon.com/gp/product/B07PFTGS2Z/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
I has 2 resettable timers so you can zero one out when you add more grease. You should connect the one of the leads to the high side of the coil that controls the motor's relay. There are 2 1/4" quick connects unused on the backside of PCB one is ground the other is 12v when the compressor is on. That way you only count when the compressor is on, not just when the power is on.
I has 2 resettable timers so you can zero one out when you add more grease. You should connect the one of the leads to the high side of the coil that controls the motor's relay. There are 2 1/4" quick connects unused on the backside of PCB one is ground the other is 12v when the compressor is on. That way you only count when the compressor is on, not just when the power is on.
Upvote 0
That's handy, but since I plan to apply grease every 5 hours, it will be easy to track with one main timer.
Upvote 0
I don’t have to do much cooling - I’m not filling tanks just topping off airguns so in my case it will be close enough.
Upvote 0
I’ve been looking at some of the air filter/dessicators for sale - most seem to be rated only to 4500 psi. Are there any that aren’t an arm and a leg that are built for 5000 psi?
Thank you in advance.
Thank you in advance.
Upvote 0
I've had success with this vibration based hour meter on my CS4. It's higher sensitivity level works better.
Upvote 0