I just purchased a brass Rowan Setback Trigger for my TX200 Mk III. Before I dig into this, I read in the instructions that there may be some interference issues at the rear of the trigger guard with the new trigger. If you have installed one of these, what should I expect in that regard ? Does their Rowan trigger guard correct for that ? I didn't see any mention of that issue at time of ordering. Thanks.
Air Arms Air Arms TX 200 Rowan Trigger question
- Thread starter erock
- Start date
I have not installed their latest design, so as the instructions say, could be. My main complaint with the Rowan Trigger is the side play. The trigger simply slides side to side on the pin, so you have to make some spacers and install each side of the trigger and let them slide on the pin.
If the set back rear hump is too big, a bit of custom fit with a small file may be required. I personally am not a fan of their product.
Cheers
Kit
If the set back rear hump is too big, a bit of custom fit with a small file may be required. I personally am not a fan of their product.
Cheers
Kit
Upvote 0
Exactly. The instructions say that I may have to slot the screw holes in my existing trigger guard to accommodate the new trigger .....
What the heck ??? Seriously ???
Upvote 0
UPDATE: Just finished the install, as part of my winter servicing/lube. The trigger fits great, and no interference or side play issue. Once I got things adjusted per their instructions, it fit as hoped. Actually, I am quite pleased with the results. It certainly achieved my intended results and works GREAT ! I appreciate your inputs. I'm calling this one good.
Upvote 0