Gambler's latest activity

Probably not the same as op asks about, but i shot 26.5gr zan (the lightest slug in .25) in my drs 600mm at 980 with pellet liner and...

Yes it will work, you just can't use a maverick barrel kit on an impact as the shroud get in the way.

Hi, does barrel and inlet assembly from impact fit on mav? On pictures the inlet looks the same, and there is no measures on the shroud...

The STUD Chain Drive "Slug Only" Mag for the FX DRS is almost here! 🎯🔥 Another first from STUD, built to give PRS .22 shooters the...

The hammer spring adjuster will be a tough one. I do not have a way to bore a hole, and to cut a slot through the top will really guy...

Its realy nice indeed :D just a question, would it be and option to make a hole for the hammer adjuster and reg so you dont have to take...

Please share your website

Yeah, if the o ring fails i just take it out and buy a slug probe, its on the shopping list together with a 700mm air cylinder anyway...

Yeah i was thinking of take abit off from the probe, i also tought about opening up the liner abit but was unsure of how it will seal...

The probe hits the liner is whats the problem, I dont know if there is any adjustments to the probe so I can dial it back 2mm? Cuz the...

Ill take it all apart tomorrow and see what I can find

Its normal to cock after I get over the "bump". And it was not like this before I moved the barrel assembley where it supposed to stay...

I dont think anything is stuck cuz I can put in a slug and push it in with a ziptie the same depth as the probe should do. It shoots...

Dont know if the vid makes justice enough for how hard it is

I did not clean anything, just loosend the 3 grup screws and pushed the barrel assembly in all the way where it supposed to be. I did...