JackHughs's latest activity

https://www.airgunnation.com/threads/moisture-filter-question.1326333/ Twenty minutes of pumping is a lot of lost air. See Post 17 of...

I had a very slow fill issue with my GX CS4 taking more than 3 times as long to fill. When it got to around 2,000 PSI it was sucking...

Check out this post (#291) about the check valve...similar to what u describe...

Have you checked the grease cup for air bubbles? It may be that your CS4 is starved for grease. There is no manual. The only thing GX...

What I learned over the past several weeks is that FX has released at least three different Panthera Parts Lists - 2023-02-02...

I leave the tanks on my guns pressurized for months at a time. So, all things considered, I guess it would be OK to leave the filters...

Start your compressor with the bleed valve open. Then close the bleed valve but don't open the tank valve until the filters are...

Bottom up. All the time no matter what projectile. Probably partially because it’s how we were taught when regs became the norm. And...

Always bottom up. Why slam the valve unnecessarily hard ? If you do a little research you can basically find out the reg pressure you...

I had this exact same failure in my MkII Impact last year. When ordering a replacement, be aware that earlier MKII's had smaller regs...

There are a bunch of posts on this subject that you can access with the "search" button. Here is a brief summary. What MV do want to...

I installed a Huma Reg on my Panthera recently. It is not a complicated procedure but there are things to consider. When you remove...

You might have an air leak. Will the regulated plenum and the main bottle hold pressure overnight? JackHughs

If you're pretty sure you'll be getting a compressor later on why not look for an SCBA tank(s) that has a couple or 3 years left on the...

Indeed can see AIR PRESSURE doing that .... otherwise no load is on the mag mechanically.