Recent content by zer0dev

All of pro class sold out in less than 2 minutes.

Yes and yes. There's an elastic pull string and a quick release tab. Only issue is if you don't have it cinched and go prone. You're susceptible to the mag falling out.

I use this (buddy got it as some swag). Or if it's cold and I'm wearing a jacked, just my pockets. https://air-marksman.com/product/airmarksman-dual-magazine-carrier/

With that much difference in length, are the weights the same?

Dude don't forget... blizzard and a healthy 7-12 mph headwind! SNOWFLAKES IN YOUR FACE! While snow is a good wind flag, it doesn't help when the targets are painted... white.

My 700 mm .30 cal U2 will comfortably make 100 fpe. Could probably squeeze a bit more out of it, but it's a good tune. Factory spring and setting, huma reg at about 170 bar.

If you really get into it, a purpose built timer will serve you better: MDT Crush-It SG Pulse Pro (announced at shot show) Precision Match Timer (Apple watch) I have the MDT, not used the others.

Smok3y found it above. Yeah that's disappointing :(

I'm interested to hear your results. Power levels and shot count would be helpful too. I found the 300 cc / 300 bar rear bottle just barely enough for longer stages (600 mm, reg at 170 bar). Do you have the internal weight set? Does UA have that available? If not, what's the weight without...

You do not need a safety for non-semi rifles.

I don't want to get off topic with this in particular, but larger caliber has an advantage on edge hits, esp if you consider the 1/4" kyl. Miniscule yes, but math is math. I'd love to hear more about this, or link to discussion. I've been toying with the idea of the DF Panthera chassis. I...

Interesting, you have a link to the product anywhere? Even on Zan's site, all I can find are the 42.3s.

Where's this marketing material coming from though? Second time this week there have been mistakes in new product announcements. The ELR's in .22 are 42.3 gr, not 35 gr.

What's the spec on the muzzle thread? The original RP was not 1/2x20 UNF.

Be careful of Amazon o-rings. Buy from somewhere reputable like oringsandmore. You could also try stepping up to a 90d. I had the same problem with Amazon crap, poor tolerances.