JTS Bolt catch snapped

[onpointairandbow]

So I purchased a heavy hammer spring for my airicuda and I'd say it was a little to heavy. Backed all the way out it did shoot faster for the first 5 shots but then I went to cock it back and SNAP POW something sounded broken bolt went limp. Took it apart and seen that the little piece that pulls the hammer back ofcourse to my luck had snapped. I'm working with the guy who sold me the spring he says he can make a stainless piece that threads in but I don't see any threads. Anyone have any idea how I could fix this? Jb weld maybe?

UPDATE!!
I've removed the broken screw from the threads with an easy out bit #1
Alien Airguns on eBay is going to send a reinforced replacement pin bolt catch thingy. Shout out to that guy.

 

[Stubbers]

You'll need to extract the broken bits from the threaded section of the bolt, or replace the bolt if unable to.

A stronger cocking lug should suffice.

-Matt

 

[onpointairandbow]

You'll need to extract the broken bits from the threaded section of the bolt, or replace the bolt if unable to.

A stronger cocking lug should suffice.

-Matt

Ok so it is threaded in there? Gotcha thanks that's helps I appreciate that.

 

[jarmstrong]

with a sharp pointed pick or scribe, you might get lucky and unscrew it out of it's hole.
I have removed broken off screws with left handed drill bits,,, put the hand held elec drill in reverse when you do it!
when the bit grabs the broken piece , it will back out the hole