Few questions. Has anyone filled one full of baffles? Have you tried to add a non DFL suppressor onto it? Anyone used it by itself ie., a giant FX Donnyfl, meaning no insides.
Thanks,
Roachcreek
Thanks,
Roachcreek
Donnyfl Extender’s
- Thread starter Roachcreek
- Start date
Hmm… that would be a good housing to test 3d printed cores or baffles.
And good day to you, Roachcreek - hope life is good out there! I am settled in NY and getting into a routine here.
And good day to you, Roachcreek - hope life is good out there! I am settled in NY and getting into a routine here.
Upvote 0
If someone is 3D printing. Here is a suppressor designed for an M4 that is supposed to be extremely effective. Like any PB though that’s shooting supersonic ammo you still have the crack. But obviously this company has done some serious research (I think) on acoustic design. Looks simple enough. 
Orion X is name of suppressor.
Orion X is name of suppressor.
Upvote 0
MrP,
It looks like all it needs is a core.
Glad to here your getting settled, I see your also reaching out beyond AF, those Krals are great guns as are the AF.
Regards,
Roachcreek
It looks like all it needs is a core.
Glad to here your getting settled, I see your also reaching out beyond AF, those Krals are great guns as are the AF.
Regards,
Roachcreek
Upvote 0
That looks awful!! Would be a nightmare to clean.If someone is 3D printing. Here is a suppressor designed for an M4 that is supposed to be extremely effective. Like any PB though that’s shooting supersonic ammo you still have the crack. But obviously this company has done some serious research (I think) on acoustic design. Looks simple enough.
Orion X is name of suppressor.
View attachment 393394
You can add baffles to their silencers of you want, but honestly depending on the power levels you are shooting....just pure volume will help greatly.
Upvote 0
That is how I was taught....Can’t help but noticing the chuck key is in the lathes chuck.
It goes against all safety Protocols...
But When I shut down my Lathe for the day and clean and oil it..
I leave the Key in the chuck....I know where it is....
Of course when I start it up again... I remove the Chuck key and go through my functions test.....
Upvote 0
Ca_Varminter,
Is that the DFL extender that Roachcreek wants to fill with a 3D printed baffle stack? If so, do you mind sharing the ID of the tube, and the internal length when the ends are screwed in tight
Upvote 0