Like new condition, purchased new in may this year, added 1 in 26 twist 30 cal tj barrel, barrel professionally machined. Ported tranfer port, valve, snd barrel to match. Machined custom, Vented air steipper with added 6 baffles and Donnyfl sumo, super quiet. Upgraded ninja regulator, reg pressure set to 3020 psi. Trigger springs replaced and sears shimmed and polished, tuned to Shoot 44 grn at 1010fps for 4 magazine's (28 shots per fill). Shoots slugs very accurate to 180 yards, consistently can hit golf balls at 150 yards. Jsb pellets very accurate as well. 200 griffin slugs and 2 magazines included. Scope not included. 30 cal is too much for my small back yard and I have too many long range hunting guns. May consider trades for pcp in .22 cal for a yard gun. Asking $650 shipped in original box

Bit of a rough start- extended Foster fitting you need for filling was nowhere to be found, & the 0DB moderator ordered with it is a .25 instead of the .177/.22 . No worries- spoke to the vendor & they're taking care of it, new package already on the way. Meanwhile, found a female Foster in my collection that is a hair longer than the others. It's just long enough to connect & disconnect, so all is well.

Couple young bucks showed up to check out the action.


Got the scope mounted & set up my makeshift "bench" to get a rough zero at what turned out to be 30 yards. Top hole is the first shot, the next few bounced around the X as I adjusted until satisfied. Then shot 7 (or 8, lost count) at the "9", pretty happy with that! Should've tried a group at 50 since the wind was almost zero, but was anxious to try some offhand. All shooting with JSB 10.34 tonight.


Shoot a lot offhand, & always worry about how I'll mesh with it in that position when I haven't fired one previously. Happy to report that after a few quick stock adjustments, it's going to work out just fine.


A bit heavier than I'm used to, which is a good thing. 9 lbs 14 oz as shown. Moderator is a Buckrail I have that was homeless. (Compared it to the .25 0DB, & they were about equal in sound- it's really quiet!) Once the correct 0DB gets here & I put it on, along with the Sightron side wheel, will probably weigh in a bit over 10 lbs.


That trigger... oh my. First electronic trigger & it's different, but boy do I like it! Have had the pleasure of owning some guns with great triggers- Taipan Veteran & Anschutz 1712 come to mind -but this may already be my favorite.
Much more "work" to be done...
- Verify my scope leveling job is spot on
- Compare 10.34 & 13.43 (both OG & RD) accuracy on High power
- Test 8.44 pellets on low power
- Chronograph strings
- Fine tune zero if necessary
- Possibly fine tune comb/buttpad adjustments
- Get dope out to 55
- Get parallax side wheel marked
- Maybe try my hand at field target???

First, going to get a tin or so through her as currently set up to get past any settling in period, & to get completely comfortable with the rifle.

Topped off my feeders about 6pm last night, woke up to two feeders half empty,
I hate Flying Squirrels, they are light enough to sit on the Grey Menace proof feeders, they eat for hours, move ridiculously fast, almost demon like, their nails up and down the trees in pitch black is f'n unnerving and they GLIDE!!! WTF..

Cam caught them last night; you can see a feeder swinging in the frame..

Great review on a awesome air rifle.

I thought this was the model that direct mounts the 4k and Thor models but alas it is the NLA stand alone model. It will BT par with Gen2 ATN scopes but is the old handheld model. Works great and is very light and compact. Took this as part of a trade and should have asked more questions…he made no wrong assertions nor misrepresention at all, I got to excited on the rest of the deal and this was added to round out the trade. This one is new no box…just put factory battery in it to check it (removed after). Asking $175 obo PayPal FnF or add fees msg for pics until uploaded here later.
I also have a NIB ATN QD 30mm mount $70 TYD or add to ABL for $225 for both.
Open to trades….30 pellets/slugs, travel compressor, 357+ UNF mods…?
Thank you,
Keahi

These are 10 tins of JSB .177 pellets , 8.44 gr , 4.52 head size and 500 pieces per tin . Sell for $135 by PayPal and free shipping CONUSA . More than 100 tins available .

Hello, I was looking to purchase a suppressor for Kral NP-03 (.177). I don't know much about suppressors and I think the DonnyFL ones look neat. But would anyone know which one fits the Kral NP-03? I'm looking at the Sumo model:
Would the first one on the list fit? (.177/.22 1/2x20 ENDCAP S6)
Would I need an adapter for it?

Thank you.

Why on earth has no one bought this gun? I wish I had the money right now. Am I missing something about it? 900 for a wood stock fx crown????

I have JSB .20 caliber pellets for sale in standard 13.73 grains and heavy 15.89 grains. There are ten tins of each weight available. Tins are 500 count and unopened. Price for 5 tins with shipping is $115.

Is it possible to damage a magnum springer shooting too heavy of a pellet? Example
Cphp 14.3 shoot 830 seem to be fine with no piston slam .H&N barracuda 18gn..seem to quiet the rifle down to a point where it seems like it's more harm than good .I don't exact speed but what I can gather it's about 770 -780.

Well I have everything for my Kratos. Rifle, scope, pellets, and was waiting on a cheapie hand pump. Mailman brought the pump Saturday so I unbox it and hook it up. Start pumping and after probably 50 strokes see the gauge is still at about 1800psi, the rifle I bought used already had 2100psi in it. Had the wife on the floor looking for leaks after I put some liquid soap on the connections. After about another 25 pumps she found a leak at the hose output fitting. Fixed that. Started pumping again and couldn't get it to go beyond about 2300psi. Found another leak and fixed that. By the time I got to 3000psi, I was in a full sweat. All this took place in about 40 minutes and we had to leave for a family reunion and I needed another shower. Not sure this is the sort of hobby for an old fat guy.

Even at 30fpe, my 25 caliber pp800 feels under-powered. I sent it off to Don Cothran to see if he'd fit a valve to in February, and just got it back today. He did not get a chance to really look at it for a large number of reasons I won't get into (personal matters for him). And I had it shipped back with a new hpa 2240 powerhouse valve not installed. I knew the tube diameter was VERY close to that of a 2240. The valve does slip into the tube and is very snug, but no binding. I need a slightly smaller oring. And a laundry list of other doable modifications that I'll be executing by hand. This should be interesting.

DonnyFL Sumo .22/.25
Light wear/usage, including a new cosmetic "ding" next to the Sumo logo. Photos below.
$95 shipped

PayPal F&F or add 3%. 7-day inspection period. 100% satisfaction guaranteed or return it.

The main difference I have observed so far is that the rattler is more powerful. The sidewinder has a removeable magazine. Anyone see other differences besides price?

Leshiy 2 for sale, 350mm your choice of barrels .22, 25 or 30. I have both regulators, you choose the old or the newer repr. Barrels will be sold separately only after the rifle is sold. The shroud is wrapped and picatinny rail epoxy to it for my red light, comes off easily. In .22 it shoots Walmart crosmans great. Great rifle, just wanting to try something new, I'm a shooter not a collector. If interested PM me for my phone number to discuss. New ones are 2470.00 now, you can get this one for 1900.00. PayPal or postal money order. I will cover shipping. The scope is not included.if this Leshiy 2 is seen anywhere but AGN, it's a fraud. All three barrels are Alphas.

I plan to install an ARH UK 12lbs kit in an HW98 .177. My goal is for a accuracy. In the past I've used Vortek lubricant, and ARH moly paste and heavy tar to tune a couple of rifles. This time I should have some Krytox lubricant available. Can anyone recommend the the best use of Krytox, moly paste, and tar for this project? I appreciate any help.

I have a loading problem when using ZAN .22 cal 23gr in my FX Crown . It seems that the slugs do'nt stand correctly in the magazine ; they are a bit slanted and the magazine doesn't rotate anymore after 1-2 shots. I have no problem with the FX Hybrid , which are a bit longer than the ZAN ; maybe these are too short and their shape doen't allow to stay "upright" in the magazine.
Did anyone have this kind of problem ?

Preparation’s have been made. Stay tuned.

Mike

Is it just because the lower caliber versions have lighter pellets or they are modified for lower power? Could you for example mod a .30cal pcp to shoot with the fpe of the .357cal version of the same rifle?

WTB - gently used Diana Air King Pro in 177. Let me know if you have one that you are interested in parting with. Established forum members only.
Thanks,
Daniel Putz

Bought this 20 cal Rapid From AZ years ago. Recently sent it off to Martin for Cosmetic Surgery. INSIDE and OUT..lol
5 shot group 75 yards JSB 13.73

Also if the pcp is leaking from the seal... Wouldnt letting the fill probe in the seal stop the leaking? Wouldnt the problem be "solved" or the rifle wouldnt let you shoot while having a leaking problem even if the seal is blocked?
(This just randomly came through my mind I dont have air leak porblem lol)

SOLD DAYSTATE WOLVERINE 2 HI-LITE 303 .30 CALIBER PCP AIR RIFLE (EXCELLENT CONDITION)

Selling Price: Daystate Wolverine 2 Hi-Lite 303 PCP air rifle $1561.00 (NO TRADES) with 1 ea. 5 shot magazine, 1 tin JSB Extract Diabolo – 44.75 grain pellets w/150 pellets per tin, and a soft rifle case.

Add $150.00 (FIRM) for Hawke 6-24x50 scope as shown.

AVAILABLE: 12ea. tins JSB Exact Diabolo 50.15 grains pellets for $22.00 ea. or $216.00 for all 12 tins.

PayPal or Postal Money Order. Buyer/Seller equal share shipping and insurance to anywhere in CONUS.

SPECIFICATIONS:

Caliber: .30

Weight: 7.5 lbs. w/o scope

Silencer: Huggett sound suppressor

Stock: Italian high-grade walnut with beautiful CNC checkering

Ambidextrous stock: for left & right-handed shooters + a thumbhole for proper trigger control.

Trigger: 2-stage match quality – adjustable

Overall length: 50 inches

Barrel length: 23 inches

Shots per fill: 20

Finish: Satin

Energy: 100 ft/lbs. with 50.15 grain pellets

SOLD BROCOCK CONTOUR ELITE .22 SUPER 6 PCP AIR RIFLE (Excellent Condition)

Selling Price: Brocock PCP Air Rifle $325.00 (NO TRADES) with 2ea. 6 shot rotary magazines, fill probe, 3-tins Discovery Benjamin pellets 14.3 grains – 500 pcs/tin, and a soft gun case. WITHOUT SCOPE.

Add $135.00 (FIRM) for Hawke 6-16x50 scope as shown.

PayPal or Postal Money Order. Buyer/Seller equal share shipping and insurance to anywhere in CONUS.

SPECIFICATIONS:

Cocking: Side bolt

Caliber: .22 (5.5mm)

Fill Pressure: 200 BAR (max)

Overall Length: 801 mm (excl. Huggett silencer)

Weight: 2.29kg w/o scope

Stock: Ambidextrous walnut thumbhole

Power: 11ft/lb.

SOLD FX ROYALE 500 WALNUT .25 CALIBER PCP AIR RIFLE (EXCELLENT CONDITION)

Selling Price: FX Royale 500 Walnut PCP Air Rifle $875.00 (NO TRADES) with 2ea. 11-shot magazines, 2 tins JSB Exact King Heavy Diablo MKII pellets 33.95 grains – 300pcs/tin, and soft rifle case. WITHOUT SCOPE.

Add $125.00 (FIRM) for Hawke 4-16x50 scope as shown.

PayPal or Postal Money Order. Buyer/Seller equal share shipping and insurance to anywhere in CONUS.

SPECIFICATIONS:

Cocking: Side Lever (very smooth)

Caliber: .25

Overall Length: 47 inches

Barrel Length: 25.5 inches

Weight: 7.7 pounds w/o scope

Energy: Up to 45 ft/lbs.