Bleed screws should be mandatory on every PCP. Should be illegal to sell one without that feature. Hope you get things figured out MACTEN.
Upvote 0
AMP Regulator is creepy..
- Thread starter MACTEN
- Start date
I'm just putting it back together as I type this. Trying to remember the washer order.. weather the left over spring was on the reg body or piston side..
Upvote 0
The extra washer should be towards the reg body. It has something to seal against that way.
Upvote 0
Thanks... I was sure mine was facing the piston end but probably was what you are saying.. Also.. Silicone oil on the washers?
Upvote 0
Got it all back together and will watch to see if it creeps.. I think it might until it seats with it's new smooth surfaces.
Upvote 0
I had one out of two facing the piston. I figured it was a mistake from the factory and put them both facing the reg body . My SD is 3fps for a 20 shot string so the regs working. Hopefully someone with more experience can clarify if the washer towards the piston is correct. I don't want give any bad advice.
The oil or grease is for the orings and I did put some on the washers.
Upvote 0