I am new to Airgun Nation. I have shot a Sheridan for years but a friend told me about this forum. Glad to be here and reading the post of interest.

This is a slug, slinging laser,About four months old bought from ed gun West.. Superb accuracy well under a half inch at 104 yards all day long with the slugs that are in the picture. Three magazines included mag holder
and rear monopod all with factory case just like brand new I have stellar reviews. This gun is a shooter.$1625 gun will come with the original grip not the one in the picture…

scope, Bipod and scope rings could be bought as well for additional price

Excellent condition 22 cal has one tiny hairline scratch that probably can come out. Just bought this from a recent member shoots. Amazing hold air. Otherwise it’s like new condition. Also comes with moderator and factory. Cap. Three magazines are included $370 shipped to your door conus

I got bored today and decided that it’s time for another round of gun vs. gun… the pic has 9 horizontal lines of 3 5 shot groups each (two lines have only 2 groups cause I ran out of light and/or the specific ammo…). Here’s what I suit and I. The order I shot it (experience shows I loose focus when shooting group after group so the later I shot it the more handicapped the gun is - by me…). Obviously this is not the order of the groups:

A. .22 Wildcat compact 18gr AEA
B. .25 Vet 2 25gr AEA
C. .22 Dreamline classic 18gr AEA
D. .25 Impact M4 34gr AEA
E. .25 P3 34gr AEA
F. .22 Red Wolf 22gr AEA
G. .22 Wildcat HN 21gr slug
H. .22 Ghost 22gr AEA
I. .22 wildcat 15gr Hades

45yards, 7mph wind with 18mph (not kph…) gusts (which I tried to wait out but yeah…). Wanna guess which gun is which?




Edit: Solution in comment #23 on the 2nd page.

Snowpeak P35 .22 caliber, overall EXCELLENT condition, has moderator adapter, mag, fill probe.
$245.00 SHIPPED

hi all,
Just a question on ammo for ratting: So far I only used slugs for longer distance because of their favorable BC. And I was looking for hunting pellets (hades, ultrashock etc) for shorter distance ratting.
But how does a hollow point slug do? Does it make a comparable damage to a hunting pellet trough mushrooming, or do hunting pellets still hold an edge for this use? Does a slug have a higher probability of passing trough?

I purchased my FX Wildcat a couple months ago and have been enjoying it since I bought it. Actually this is my 3rd Wildcat. The first was a .22 gen 2 compact I eventually gave to my son. The second was a M3 sniper .25 I traded in for the M3 Impact. All 3 have come from the factory with phenomenal performance straight out of the box. I really missed my Compact Wildcat, so I decided to get another. When I say phenomenal this is what im talking about. As much as I'd like to take credit for the tune I haven't touched the settings on this gun. It shoots dime size groups @ 50 yards when the wind Gods are favoring me. This is a magazine (18) The chrono didn't record 1 shot. I get 3 mags(54) shots on a 225 bar fill on reg. .22cal 18gr JSBs

Here’s a little old school cool to show off. This is a Huntsman Midas MKI in .22 that was made from 1983 to 1992. It has a fill pressure of 3k psi, but to operate in the "sweet spot”, I fill to 2300 psi. I get about 50 good shots in the 15 ft. lb. range. I believe these first Daystates used BSA barrels which are pretty dang good. I hadn’t shot this for quite awhile, but I think I’ll put it back into rotation for a bit. I just need to figure out which scope I want to use.

Selling this nice colored walnut stocked TX with custom brass trigger guard and scope. Note the striping on the stock. Has a single small dent in the stock behind the cocking lever slot but no marks on the metal that I can see. Very close to perfect.
Scope and shipping are included. I will ship the action out of the stock and scope off, all padded to keep the package short.
Thanks for looking,
Bob

I use this gauge assembly when I want to shoot tethered to one of my tanks. Today I discovered the cap that keeps the oil inside had come off of both gauges and the oil was all over the regulator and a bunch of other stuff that I kept stored in the same drawer. Do you think any oil seeping into the regulator would affect it's performance? Are gauges typically filled with mineral oil, and all I need to do is fill them back up enough to cover the gauge needles?

Less than six months old comes with three magazines, magazine holder. This gun is extremely accurate tune for 18.13 JSB‘s quarter inch groups at 80 yards sparrow heads shots at 60+ yards absolute incredible accuracy and shot count.. purchased brand new from Ed Gunn West. The only reason for selling is just bought a brand new L2 22 Ed gun I really don’t care if I sell this or not this gun is absolutely incredible. Will come in original high-quality case and boxed shipped insured and signature required. Thanks for looking. You can check out my reviews. They are stellar.

$1550 shipped to your door. conus
bipod scope,mount, moderator are not for sale.

More gadgeteering from the dark recesses of accumulated stuff...and my sketchy old memory.

Back in the day, Robert Law at Air Rifle Headquarters in WV commissioned Williams to make airgun-specific peep sights. These were similar to today's FP and GR series, but with fixed mounting rails mating with each brand's dovetail spacing. They are secured by setscrews on top, to snug the sight up tight against the grooves.

This is the "ARH 624," a sporting peep sight (Weihrauchs had wider 13mm grooves back then, so the ARH peeps are a rare alternative to HW's own match diopter of the day). Seen here on an old HW 30:


And here on a vintage HW 50 is the "ARH 834T," the target version of the same sight, adding finger-knob adjusters and a taller elevation arm.


Next, a challenge - a BSF S54 Match underlever. This eccentric design has: A) relatively low front sight; B) barrel set below the top of the receiver; and C) high rail for the rear sight...so any rear-mounted sight must adjust VERY low. BSF's match diopter works of course, but is fragile, adjusts coarsely, and doesn't take German eyepieces! ARH also had custom Williams sights for BSF barrel-cockers, but they won't go low enough for the S54. The one sight that WILL go low enough is the current FP-GR, but its tall elevation arm strikes the gun's wood (note: the FP-GR may work as-is for those versions of the S54 with narrower stocks).


The solution was a mix'n'match. The base is from a brand new FP-GR, with the shorter top from an "ARH 833T." A tidy setup, with the bonus of better precision than the OEM sight.


And a surprise bonus...the other half of each sight was not wasted. The 833T's rails are about 11mm, so its base plus the FP-GR's top gives a 1980-vintage HW 35E (with 22-inch barrel) a sight radius that's almost silly.


Here is the whole motley old crew with their new "eyes," ha.
Here

I cannot find where I can add an item for sale on the classified forum I just joined a couple of days ago.
Thank you
Steve Armstrong

Code : WARMER

Need a good backpack gun the Katran SC hits a lot of the check marks.

Is there anything else that is just as short, good ergos and around the same price?

This is my Walther LGU Master underlever, spring piston rifle in .22. The Walther LGU Master was only made from 2015 to 2017, but the .22 version was only made in 2015. Overall, it is in stunning condition, fully functional and very accurate. This is a European 16j model (12 ft. lbs); I've attached a copy of a ten shot string from today that shows an average fps of 537 with JSB 15.89 gr. pellets (see pics). Price is $850 OBO. Shipping is free to the lower 48. Payment by USPS money order, or Certified Bank Check. If you have a lot of positiver feedback and/or a strong forum presence, I’ll take a personal check.

A Snowpeak M60B was my first airgun, the more powerful MAX1 has been a teaser for many for a while now and the picture of the shot show the first time i've seen it spotted 'in the wild'. But what about those new AP models? Does anybody know a bit more about them?

14" barrel NP-03 breech and cut down the factory stock. Dual front bottles and a rear. Will end up with probably all three bottles being 300-350cc Carbon Fiber to keep it light and 1000cc is still plenty of air. This is in .177 slinging slugs right at 950fps. Just a mock up still a little stock work to finish.

Niksan Elf-S Bullpup .22, includes 4 magazines, factory hard case, probe, tools, O-ring, forearm grip with push button bipod deployment and manual all like new condition, less than 100 shots through it. The original owner won it NEW at an airgun event and fired one magazine to verify function, I fired 4 magazines through it with 4 different pellets. I decided to stick with my Beeman 1358 bullpup. See review link in last photo. -- $285.00 Shipped -- PayPal Friends & Family, (add $15.00 to cover fees if PayPal as purchase), or USPS Money Order. Trades or partial trades possible *** send a picture of what you have to trade *** I do not want breakbarrels.

I was doing some rats shooting this evening and I managed to tag one. Probably 15 minutes later I scanned the area for more rats and the dead rat had disappeared. My initial thought was the barn cat or owl had taken it so I didn't pay much attention to it. Another 15 or 20 minutes passed, I scanned the area again but this time I was using my handheld night vision unit instead as it was much easy to just scan around for targets.

Well, a coyote appeared in my scope view and I almost sh!t myself as I didn't expect to see one. I tried to switch to my gun but my movement had scared it away. The coyote was only 30 yards away. Yup, expect the unexpected next time out. What a missed opportunity.

Ok guys I made my mind up im ordering a Impact m4 600 mm in .30 cal what are some good pellets to start out with. Thanks. I have never owned a .30 cal pcp alot of .25 and .22 but never a fx or .30 can't wate lol

Have several Optics for Sale
WestHunter 6-24X50 FFP No Box $125 Shipped

Barska 1X40 Ion Reflex Sight Red Multi Reticle $85 Shipped
Sight Mark Ultra Shot R-Spec $95 Shipped

All used all function as they should
Postal MO

This looks interesting...