I have a Leshiy 2 repr that I installed a 500mm .30 FX Barrel with huma adapter and superior liner installed. It’s currently shooting 44grain jsb pellets at 860fps with reg at 150b. Lots more power on tap, just didn’t need it super powerful.

Has carbon fiber handguard, with utg recon Malcolm bipod legs attached. Comes with 1 mag, jkwan scope rail mounted mag holder, and fx impact shroud on barrel.

Asking $2000 shipped east of Mississippi. Shipping a little pricier to go farther, but can work something out.

Moderator, scope, and bottle not included.

Thanks for looking.

Anybody else check their first shot POI in preparation for hunting season? I got new P35s in 177 and 22 caliber and have been getting them ready for our October 1 opener for small game season. I adjusted the zero to an estimated 38-40 yards (can't shoot past 33 in my yard) and found the POI was moving a bit day to day. The 177 has been fine for several days now so I am confident in it. The Athlon 6-24 on my 22 was scaring me but yesterday it was the same in the afternoon as the morning and this morning it was still the same. All were slightly low for 25 where I check when it's windy as it is today. So I turned it up a few clicks and seem to have it dialed in. Now if it holds that when I check after lunch I think I may use it first. Saturday is looking bad here due to Ira but I should have a chance to get out early next week.

My scopes all cost about $200 so they are definitely not high end. They work fine. But sometimes it seems to take them awhile to settle after adjustment. So I like to take them out and shoot a few shots once or twice a day to make sure they are staying sighted in. If it's windy like it is today I don't worry if the impact is a little in the direction the wind is blowing but if it moves opposite to the wind or moves much in elevation I start to worry a bit about the scope. The POI on the P35-22 initially moved due to the shroud moving forward allowing the shorter hair curler to tilt and get in the way of pellets causing clipping (I had an issue in the shroud). I turned the Athlon all the way to the limit down before I figured out it was clipping. But after I fixed the shroud and resighted the first few checks had the POI moving an inch or so at 25 yards - a lot. But after that it has been at most a few clicks off.

I enjoy finding an accurate pellet for new rifles and on the P35s changing the shrouds to make them quiet and checking penetration in wet paper of the pellets they like. All part of my process for "getting ready". Verifying first shot POI is about the last step for me.

Well apparently the taipan stocks from 2015 were milled a little different than the new ones and the tolerances just wouldnt allow the supervet to line up in the new stock so I put it back in its original stock, I don't have the balls to start working on the stock he just refinished to get the supervet to fit...

The pics dont do the work that was done to the stock any justice the color is very very nice

Anyways

Huge shout out to Eddie ( @Cannonball ) for his work on the night time taipans stock

He stained it , his choice that I rolled with and I could not be more pleased just look at it

Gun is only a few months old. does not include scope. gun comes with Donnie FL Ronin. Gun is in good shape everything works as it should no leaks.

$2000 shipped paypal friends and family

Can you use armor all on a PCP air rifle??? Armor all should be good for silicone and rubber??? Seems like it would work well to lubricate and clean. Does anyone do this or is this just stupid???

I want to cut into a very nice wood stock to create an adjustable cheek weld. Where do you buy the hardware to create the interface between the shoulder and cheek? The below link is Australia

Airgun is new in the box never fired. Purchased it and then found another gun I was looking for. Comes with a Donny FL adapter, Buck Rail tri-rail barrel band, and Buck Rail scope rail support. As it came from the factory. $475.00 shipped to the lower 48 only. PayPal FF.

This is basically new in box. I mounted on my rifle and shot maybe 6 shots. I can’t get used to the first focal plane reticle. It comes with the side wheel, sun shade, lens covers, and power lever. $650 shipped

EBR starts next Thursday, but many of us that are shooting EFT that Thursday will be shooting Ben's XFT night match Wednesday at PR&GC. Looking forward to EBR this year, attendance sold out the first couple of hours...
Team Centercut will be there, so if you see the black and orange shirts and hats, stop by and introduce yourself. On Friday and Saturday we'll be at the Big Bore range (when we're not shooting of course) with the Airguns of Arizona Demo guns and some TC pins and stickers... In the past, we have put our AGN handle on the EBR nametag so those that participate in AGN know who we all are...

This year TC will have:
Mike B @Centercut
Gabe V @Gabester
Dave W @dwilson050
Scott H @Scotchmo
Tony P @pesty3782
Barb P @5Power
Peykan B @CactusPilot

The Texas boys couldn't make it this year, Derrick W @zx10wall and Bill M @Crusher

I just don’t use this gun like I thought I would. Functions flawlessly and very accurate with JSB 16 grain. I refinished the stock because the factory finish is just ugly in my opinion. Completely sanded the old finish off and stained with dark walnut minwax stain. Protected by several layers of tru oil. Will include the extra mags. Case, red dot, and anything else besides the gun and extra mags is not included. Asking $550 or best offer. PayPal only. I’ll split shipping with the buyer. Continental United States only and only were legal. Thanks for looking.

Edit: I’ll include the red dot sight with the rifle if wanted.

Only a few tins through it got last year from UA along with the Aeron Hunter Stock (with pic t-rail) which is really great for this rifle. Included blue 0DB110c moderator, matching blue west hunter rings and Leaper 4x16x50 scope. Also comes with original synthetic stock as well so really like two rifles in one one for hunting and one for target work! Just selling to fund another rifle. $1600 shipped PP FF (so no no fees) to the lower 48.

This afternoon, after I got home from work, I saw a package sitting out on the porch and was reminded that I had bought a few tins of JSB 33.95 Jumbo Kings from PA.

OKaaaay, Mr. AEA Varmint had not eaten any of these yet and since there are so many good report on them bing very accurate, I thought that I would load up a magazine of them and go to the range, sit at the bench and see what they do. Well, just as I sat down, Bob (the grey squirrel that lost its tail in a dog fight last year) came down out of the Oak tree next to the 50y range and started planting acorns. I like Bob but sighted in on him just to appreciate this funny looking squirrel.

Then it happened. Mr Red squirrel jumped down off the pile of pallets SWMBO has for her raised bed garden and started yelling at Bob!

Mr Red sits on the wood pile (100 feet long, 8 feet wide and 6 feet tall) and controls SWMBO and I as we navigate the yard and eats the pine cones normally but he never goes in to the back yard where Bob lives and frankly, I was just about fed up with Red yelling at me anyway and with him chasing Bob and yelling at him, I guess I snapped.

Red jumped up on the trailer, faced Bob, who by now had retreated back up the Oak tree and started hollering again, I swept him with the BugBuster, set the crosshairs on him just behind the eye and squeeezed.

Say what you will about .25 cal and round nose pellets, "over penetration" and all that. Mr Red got a lead lobotomy and it sounded as if I took my framing hammer to a ribeye! Mr Reds brain escaped his noggin and displayed itself all over my trailer bed and Mr Red STOPPED YELLING!!!

What's the issue, you may ask? This lowly AEA bolt action LOVES the 33.95 pellets and is sub MOA at 71 yards. I'm gonna need and intervention to keep me from punching that Buy Now button at PA!

What started out as a hopeless gun has really shown it's worth today and I could not be happier!



Same hole on both sides.



Three sections of grey matter



Pre sight-in, set for JSB 25.5gr Kings, 50 yards, the bottom 2 dents are 6 pellets, look closely and you can see the ring of each one, 0.040" center to center. The top splash is a 25.5 from yesterday.

Hopefully, will get some time to zero and shoot a few groups this weekend.

Looks very well made, very happy fellow I.

I’ve got an abundance of extra pellets. Hit me up if you are in need.

$12 per tin for 200ct JSB
$20 per tin for 350ct FX





Shipping based on how many you want vs how many will fit in a USPS flat rate box.

DM me with any questions.
-Michael

Hey guys and gals. I recently posted a WTB parts as and Thomas Imperati from Branford CT responded back and said he had what I needed. I sent him money on Zelle and he said he was too busy to send me the parts now and kept blowing me off. I kept asking for the parts to be shipped and provide me a tracking number and he kept ignoring me and when he responded he just said ok I will. I’ve told him many times via zelle for a refund and he refuses. No parts and no refund. Avoid at all costs. Worse yet he is an ffl card holder. I provided his info to help you guys out.

#1 Colt NRA .177 like new $70

#3 Benjamin Franklin 132 works as it should. Holds air, very accurate. $100

#4 Legends M712. $80

717 698 8948 call or txt

Shipping available at buyers expense.

Selling this great looking RAW woodland camo stock. The stock is like new, save for one very tiny almost invisible pressure mark at the point of the cocking lever,see photo.The stock has the accessory rail { forend plate not included }, adjustable cheekpiece and butt pad.Decided to go to a chassis stock. Great if you are looking to go the other way.Asking $325.00 OBO shipped to CONUS. Thanks for your interest.
Richard

How do you know were you there to see? Can't cook at a shoot with friends?

Ok going to a shoot using my gamo .22 and cook out i ran in to walmarts to grab some pellets ( cphp) and charcole . Well no kingsford so i grabbed this walmart brand stuff. Would not burn unless fed plenty of fulid.lol. Lucky my Buddy had extra kingsford and made it. Used some of the bricketts as targets . So put it up and forgot about it till today and fired some up. Well failed again ice cold after the fluid burned off.( Twice) So more brickett target shooting till i throw the test on the burn pile..lol i like how they " explode" with a good square hit.. kinda fun

Friend of mine picked one of these up thinking he was going to get more into airguns..... and sadly he hasn't. So he has asked me to try and sell it for him.

Stock EdGun lelya2 .25, she shoots as you would expect. Has a lovely walnut stock along with 3 mags.

Will post up pictures later today.

He is looking to get $1400 for the rifle. And can discuss shipping

I have two of these on the way, one in green laminate and one in synthetic. I am selling one and keeping the other one. Laminate is $1750 and the synthetic is $1650 TYD.. I am not interested trades as I need to pay that CC off.

Wonder if this ships with some of whatever drugs the seller is on? What do you think?

THINK WE SHOULD ALL SAY A PRAYER FOR ALL THE FLORIDA RESIDENTS TODAY HOPE THEY ARE ALL GONNA BE OK

Share your past experiences and help fellow shooters hone their craft and shooting ability!!



*The idea for the this thread is compliments of Air Arms

Used once. $50 shipped CONUS.

***Sold pending funds***

Up for grabs,
is my EDgun R3 .30 caliber.
Gun is a single shot EDgun, which are arguably some of Ed's most accurate to date.
Stock was somewhat plain, so original owner stained it red. Hence it's stable name; RedEd.
Gun has larger John Hagan valve stem.
Gun was gone completely over by Motorhead a lil over a year ago. He replaced all orings, rebuilt regulator, and lightened, smoothed out that less than great, stock Edgun trigger. Makes for one sweet bench shooter, that's as accurate, if not more, than any Edgun I've ever had. With that dream target trigger you won't be able to cock it when the gun is up and down, vertical. It cocks without a beat, when the gun's horizontal. I have not firmed the trigger up, which would correct this; because shooting it off the bench is simply sublime. It's got an awesomely tight shot string too. Check out the pics below. Shot string is shooting 44.75gn.
I'm asking $795 shipped. PayPal f&f. No trades, as I'm trying my hardest to downsize. If this post says WTS. then yes, its still available.